4 Handling the Rack after Installation 165
E
4.6.2 Mounting the rail units
Secure the rail units to the rack posts using the M5 cage nuts that were attached in step 1 and 2
according to "4.6.1 Inserting cage nuts".
1 Push the left and right disconnect springs on the slide rails to release the
lock of the table unit, and then remove the rail units from the table unit.
2 Fit the rear brackets of the rail units in place on the rear posts of the rack.
Then, using the supplied M5 screws, secure them to the M5 cage nuts that
were inserted in step 1 and 2 into the rack posts (front and rear) according
to "4.6.1 Inserting cage nuts". (Eight screws)
Loosen the two adjusting screws on the rear brackets to adjust the units to the
appropriate pitch between the rack posts (front and rear) on which they are
mounted. After the adjustment, fully tighten the screws.
Disconnect spring
Push in this direction
Table unit
Rail unit
Rail unit
Rack posts (rear)
Rail unit
Front
M5 screw
Part to be inserted
Rear
M5 screw securing
holes
Rack posts (front)
M5 screw
Rail unit
M5 screw securing
holes
To Next Page
Loading...
Need help?
General