100
CD-ROM Drive
Your CD-ROM drive is durable but you must
treat it with care.Please pay attention to the
following points:
■
The drive rotates the compact disk at very
high speed. Do not carry it around or subject
it to shock or vibration with the power on.
■
Avoid using or storing the drive or CDs
where they will be exposed to extreme
temperatures.
■
Avoid using or storing the drive or CDs
where it is damp or dusty.
■
Avoid using or storing the drive near
magnets or devices that generate strong
magnetic fields.
■
Avoid storing the drive where it will
be subjected to shock or vibration.
■
Do not disassemble or dismantle
the CD-ROM drive.
For guidance on loading a CD in your CD-ROM
drive and caring for CD-ROMs see Section Two.
(pages 36-37.)
3. Set the device adapter for Multi-function
Bay 2 on top of the Multi-function Bay 1
device and adjust until the finger ridge shows
through the hole in the device adapter for
Multi-function Bay 2,and the alignment pins
on the Multi-function Bay 1 device fit in the
small round holes of the device adapter for
Multi-function Bay 2.
4. Hold the two parts together while installing
in Multi-function Bay 2 according to the
preceding directions.
To remove a module from the device adapter
for Multi-function Bay 2 simply pull them
gently apart.
Figure 4-5 CD-ROM Drive
Figure 4-6 Optional Second Hard Drive
C A U T I O N
The module is not locked into the Device
Adapter for Multi-function Bay 2. Be
careful to hold on to both parts or you
can easily drop and damage a module or
the adapter.
To Next Page
Loading...
