121
5. Setup utility is set to something other than 5. Revise BIOS settings to set IDE Adapter
CD-ROM for the Secondary Master Controller
. 1 Master correctly. (See Main menu and
IDE Adapter submenu pages 56-62 for
more information.)
6. Wrong drive designator was used for 6. Verify the drive designator used by the
CD-ROM in the application application is the same as the one used by
the operating
system. When the operating
system is booted
from a CD-ROM drive
designations are auto
matically adjusted.
(
See Boot Options
submenu on pages 63-64.)
7. Windows CD auto insertion function 7. Start the CD from the desktop or
is disabled. application software or re-enable the
WindowsCD auto insertion function.
(See CD-ROM Access Indicator on pages
21-22 for more nformation.)
The CD-ROM Access indicator on the Status 1. The Windows CD auto insertion function 1. This is normal.
Indicator panel blinks at regular intervals when is active and is checking to see if a CD is You can disable this function if you wish.
no CD is in the tray or the CD-ROM drive is ready to run. (See CD-ROM Access Indicator on pages
not installed. 21-22 for more information
. )
Docking Problems
Notebook does not turn on when installed in 1. LANdock AC adapter is not 1. Provide power to the LAN-Docking
Docking Station. plugged in. Station.
Problem Possible Cause Possible Solution
To Next Page
Loading...
