Fujitsu ACUH09LUAS1 Design & Technical Manual

16) Outdoor temperature zone boundary temperature B
Setting required if changing of the outdoor temperature setting for heat pump only zone is required
when auxiliary heater control by outdoor temperature 1 is performed on the indoor unit. For details,
refer to “External heater output” in Chapter 8-4. "Details of function" on page 31.
Function number Setting value Setting description Factory setting
67
00 42.8 °F (6 °C) ♦
01 14.0 °F (-10 °C)
02 17.6 °F (-8 °C)
03 21.2 °F (-6 °C)
04 24.8 °F (-4 °C)
05 28.4°F (-2 °C)
06 32.0 °F (0 °C)
07 35.6 °F (2 °C)
08 39.2 °F (4 °C)
09 42.8 °F (6 °C)
10 46.4 °F (8 °C)
11 50.0 °F (10 °C)
12 53.6 °F (12 °C)
13 57.2 °F (14 °C)
14 60.8 °F (16 °C)
15 64.4 °F (18 °C)
17) Standby time for auxiliary equipment operation
Sets the standby time until the auxiliary equipment operation starts during primary equipment opera-
tion.
For details, refer to Chapter 8-4. "Details of function" on page 31.
Function number Setting value Setting description Factory setting
71
00 Disable ♦
01 1 minute
02 2 minutes
• •
• •
• •
98 98 minutes
99 99 minutes
18) Heat pump backup setting
Enables or disables the heat pump backup instruction from the outdoor unit.
This function will be usable provided that the corresponding outdoor unit is connected.
Function number Setting value Setting description Factory setting
72
00 Disable ♦
01 Enable
19) Emergency heat for external output terminal
Enables or disables emergency heat input.
Function number Setting value Setting description Factory setting
73
00 Disable ♦
01 Enable
NOTE:
When this function is used, IR receiver unit is necessary.
- 64 -
9-2. Function settings by using remote controller 9. Function settings
CASSETTE TYPE ADUH09-18LUAS1 CASSETTE TYPE ADUH09-18LUAS1

Fujitsu ACUH09LUAS1 Specifications

General

Brand	Fujitsu
Model	ACUH09LUAS1
Category	Air Conditioner
Language	English