Fujitsu AOYG45LAT8 User Manual

1-26. LOW NOISE MODE
1-25. ENERGY SAVING PEAK CUT FUNCTION
01-40
(Table 21 : Outline of ENERGY SAVING PEAK CUT FUNCTION)
MODE1
0%
(Forced thermostat-OFF)
MODE2
50%
MODE3
75%
MODE4
100%
(Rated)
*The performance drops when operating in the LOW NOISE OPERATION.
The current value is limited to reduce the power consumption by external input terminal 3(CN933).
When
this function, "CURRENT OVERLOAD OPERATION", "ECONOMY OPERATION"
and "LOW NOISE OPERATION" are effective, the
outdoor unit will operate by lowest current of them.
*Percentage is rated electrical power ratio
The outdoor unit operation changes from the capacity priority to the low noise priority
by external input 1(CN931).
The compressor speed and outdoor fan speed are limited as following table.
When "CURRENT OVERLOAD OPERATION", "ECONOMY OPERATION" and "PEAK CUT OPERATION"
are effective, the outdoor unit will operate by lowest current of them.
( Table 22 : Detail of LOW NOISE OPERATION)
Cooling mode
Heating mode
11.0A
17.0A
22.5A
Compressor stop
ENERGY SAVING PEAK CUT OPERATION does not operate in following conditions.
Compressor start-up process
Defrost operation
Oil recovery operation
Check run
.
.
.
.
LOW NOISE OPERATION does not operate in following conditions.
Compressor start-up process
Defrost operation
Oil recovery operation
Check run
.
.
.
.
Cooling mode
Dry mode
Heating mode
Limit compressor speed
Limit compressor speed
Limit fan speed
Limit fan speed
MODE1 MODE2 MODE3
52rps 36rps
690rpm 390rpm
55rps 42rps
690rpm
45rps
580rpm
49rps
580rpm 390rpm
(Relative to the rated sound pressure level)
Dry mode

Fujitsu AOYG45LAT8 Specifications

General

Brand	Fujitsu
Model	AOYG45LAT8
Category	Air Conditioner
Language	English