Fujitsu AUG12LVLB - Indoor heat ex. thermistor error

-
(
01 - 40
)
-
CASSETTE TYPE AU

G12-24LVL
CASSETTE TYPE AU

G12-24LVL
CONTENTS OF FUNCTION SETTING

Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in •
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value. •
Settings will not be changed if invalid numbers or setting values are selected. •
1) Filter sign
2) Ceiling height
3) Outlet directions
4) Cooler room temperature correction
5) Heater room temperature correction
6) Auto restart
7) Indoor room temperature sensor switching function
8) Remote controller signal code
9) External input control
10) Indoor unit fan control for energy saving
1) Filter sign
The indoor unit has a sign to inform the user that it is time to clean the filter. Select the time setting
for the filter sign display interval in the table below according to the amount of dust or debris in the
room. If you do not wish the filter sign to be displayed, select the setting value for "No indication".
(

. . .Factory setting)
Setting Description Function Number Setting Value
"Standard
(2,500 hours)"
11
00
"Long interval
(4,400 hours)"
01
"Short interval
(1,250 hours)"
02

No indication 03
2) Ceiling height
Select the setting values in the table below according to the height of the ceiling.
(

. . .Factory setting)
Setting Description Function Number Setting Value

Standard
(2.7m)
20
00
High ceiling
(3.0m)
01
The ceiling height values are for the 4-way outlet.
Do not change this setting in the 3-way outlet mode.
3) Outlet directions
Select the setting values in the table below for using a 3-way outlet.
(

. . .Factory setting)
Setting Description Function Number Setting Value

4-way
22
00
3-way 01