Getting started
Adjusting portrait format
The monitor can be rotated from horizo ntal format (landscape mode) into
vertical format (portrait mode).
► Grasp the monitor w ith both hands on the right and left edge of the casing, move it into
the highest position and turn it clockwise until it is in the p ortrait position.
For you to be able to display the screen contents in portrait mode, your graphics card
will also need to supp ort this function or you will need to use special software.
In the OSD menu you have the option of switching the OSD manually
from landscape mode to portrait mod e (see "
Changing the monitor
settings using the OSD menu", Page 16).
To reset the monitor to landscape mode, the monitor should be turned anti-clockwise.
The OSD display can be reset again in the OSD menu.
Removing monitor base
Before you can use a swivel arm or a wall bracket, you must remove the monitor base.
The display surfa ce is susceptible to scratching!
► Switch off the monitor and pull the power
plug out of the power socket.
► Lay the monitor on its face on a soft surface.
► Remove all cables.
► To remo ve the monitor base, undo the
screws on the m onitor base.
You can now mount a swivel arm or a wall
bracket in accordance with VESA FPMPMI
using a hole spacing of 100 mm.
For instructions on how to mount the
swivel arm or wall bracket, please
see the document ation for the swivel
arm or wall bracket.
For instructi
ons on how to mount the swivel arm or wall bracket, please see
the document
ation for the swivel arm or wall bracket.
10 A26361-K1333-Z220-1-7619, edition 1
To Next Page
Loading...
