Working with the noteb ook
Connecting the mains adapter to the Port R eplicator
3
1
2
► Connect the power cable to the
mains ad apter (1).
► Plug the power cable into the mains
socket (2).
► Connect the mains adapter cable to the DC
jack (DC IN) of the Port Replicator (3).
When the notebook is connected to a Port Replicato r, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will be loaded, as
soon as th e notebook is connected to a Port Replicator of the same type.
Switching on the notebook via the port replicator
► Press the ON/OFF button on the p o rt
replicator to switch the notebook on.
The power-on i ndicator of the Port
Replicator lights up.
Switching off notebook via Port Replicator
► Close all applications and shut dow n y our operating system (please refer
to th e manual for the operating system).
If the notebook cannot be shut down properly, press the ON/OFF button
on the Port Replicator for about four seconds. The note book w ill switch
itself off. Any unsaved data may however be lost.
46 Fujitsu
To Next Page
Loading...
