3 Copyright 2011 FUJITSU
TechNotesD307x-S V1.1
Safety Instructions
Do not connect or disconnect any cables or modules to or from any onboard connectors (except
for the rear I/O connectors) until the mainboard is completely powered down.
Any damage caused to the mainboard by misuse of the onboard connectors is excluded from the
standard warranty. Fujitsu Technology Solutions cannot be held liable for any damage that results
from incorrect use of any onboard connectors.
The system integrator is fully responsible for the usage of appropriate connectors and cables in
order to fulfill the technical requirements (electrical contact, durability, power/current levels,
signal integrity etc.)
Important Note (D3243-S):
If the Power Supply is changed from Multirail to
12V only or vice versa, make sure to disconnect
the mainboard D3243-S from any power at least
for 10 minutes!
To Next Page
Loading...
Need help?
General
