Fujitsu D3320 PRIMERGY BX2560 M2 - Memory Status; Memory Configuration

BX2560 M2 D3320 - BIOS Setup Utility 31
Advanced menu
4.6 Memory Status
In this submenu the memory modules can be marked as faulty. Faulty memory
modules are no longer used when the system is rebooted if at least one
errorfree bank is available. The memory capacity is reduced accordingly.
DIMM-xx
Displays the current status of the memory modules.
Enabled
The system uses the memory module.
Disabled
The system does not use the memory module. It was manually
disabled.
Failed
The system does not use the memory module. It was disabled
automatically by the system after a memory error. If you have
replaced a defective memory module, you must set the entry to
Enabled again.
Empty
There is no memory module populated.
4.7 Memory configuration
The following parameters can be set in this menu. Some of them are only
available under special preconditions.
Memory Mode
Memory capacity can be reserved for possible error treatment. For
detailed instructions refer to the "FUJITSU Server PRIMERGY
BX2560 M2Server Upgrade and Maintenance Manual".
Normal
No additional memory capacity is reserved for error treatment.
Mirroring
The BIOS divides the system memory in half and retains two
copies of all data in the memory. It prevents a system crash when
uncorrectable errors occur. In seldom cases in which