Fujitsu D3320 PRIMERGY BX2560 M2 - iRMC LAN Parameters Configuration

60 D3320 - BIOS Setup Utility BX2560 M2
Server Mgmt menu
Action
Determines the action taken after the boot watchdog expires.
Continue
The system continues to run.
Reset
The system is restarted by a system reset.
Power Cycle
The system is restarted by a power cycle.
iRMC LAN Parameters Configuration
Calls a submenu used to make settings for the Remote Management
Controller (see "iRMC LAN Parameters Configuration" on page 60).
Console Redirection
Calls a submenu used to make settings for the terminal communication
(see "Console Redirection" on page 64).
7.1 iRMC LAN Parameters Configuration
The following parameters can be set in this menu. Some of them are only
available under special preconditions.
Management LAN
Enables the LAN interface, which can be used by the iRMC.
Disabled
The iRMC LAN interface is disabled.
Enabled
The iRMC LAN interface is enabled.
iRMC MAC Address
Shows the MAC address of the iRMC. The iRMC MAC address is divided
in blocks, separated by colons.