44 D3320 - BIOS Setup Utility BX2560 M2
Ipv6 PXE Support
Specifies whether the PXE UEFI Boot via Ipv6 for installation of operating
systems is available in UEFI mode.
Disabled
PXE UEFI Boot via Ipv6 is not available.
Enabled
PXE UEFI Boot via Ipv6 is available.
4.15 Option ROM Configuration
Calls the submenu Option ROM Configuration.
Launch Slot n OpROM
Controls if legacy Option ROMs of expansion cards mounted in this slot
shall be started.
Disabled
Does not start Option ROMs of expansion cards in this slot.
Enabled
Starts Option ROMs of expansion cards in this slot.
4.16 iSCSI Configuration
If a UEFI driver for a LAN/CNA controller (onboard CNA or PCIe card) is loaded
the parameter for booting via iSCSI can be configured here. The menu is
intended for UEFI drivers only. The menu does not apply to legacy OpROMs.
If no UEFI driver for a LAN/CNA controller is loaded or there is no LAN/CNA
controller present in the system, this menu is not used.
4.17 UEFI Device Driver Setup
An UEFI Device Driver might support an interface to UEFI FW Setup and
provides a list of information and control items. Available UEFI Device Drivers
are for example Intel
®
Ethernet Connection I217-LM and Intel
®
I210 Gigabit.
To Next Page
Loading...
