Fujitsu D3320 PRIMERGY BX2560 M2 - Network Stack Configuration

BX2560 M2 D3320 - BIOS Setup Utility 43
Advanced menu
Change Settings
Selects the base I/O address and the interrupt used to access the
corresponding serial port.
Auto
[IO=3F8h; IRQ=4;]
[IO=3F8h; IRQ=3,4,5,6,7,9,10,11,12;]
[IO=2F8h; IRQ=3,4,5,6,7,9,10,11,12;]
[IO=3E8h; IRQ=3,4,5,6,7,9,10,11,12;]
[IO=2E8h; IRQ=3,4,5,6,7,9,10,11,12;]
The serial port uses the selected address and interrupt from the
list above. In case of a resource conflict the setting might be
changed to 'Auto'.
4.14 Network Stack Configuration
Network Stack
Configures whether the UEFI Network Stack is available for network
access under UEFI. E.g.: is the UEFI Network Stack not available there
is no UEFI installation possible via PXE.
Disabled
The UEFI Network Stack is not available.
Enabled
The UEFI Network Stack is available.
Ipv4 PXE Support
Specifies whether the PXE UEFI Boot via Ipv4 for installation of operating
systems is available in UEFI mode.
Disabled
PXE UEFI Boot via Ipv4 is not available.
Enabled
PXE UEFI Boot via Ipv4 is available.