Fujitsu D3320 PRIMERGY BX2560 M2 - Page 56

56 D3320 - BIOS Setup Utility BX2560 M2
Server Mgmt menu
Sync RTC with Mgmt. Blade
Specifies if the RTC is synchronized with the management blade.
Disabled
The RTC will not be synchronized with the management blade.
Enabled
The RTC will be kept in synchronization with the management
blade.
I Please set Sync RTC with Mgmt. Blade to Disabled, if you want to set
BIOS time to UTC.
Onboard Video
The graphics controller on the system board can be deactivated if a
display card is installed in the system.
Disabled
The graphics controller on the system board is disabled.
Enabled
The graphics controller on the system board is enabled.
Boot Retry Counter
Specifies the maximum number of attempts to boot the operating system.
Each failed attempt is followed by a system reboot after the time set in
Boot Watchdog has expired. Other critical system errors also result in a
system reboot and a counter decrement. After the last attempt, the
system is ultimately powered off.
Allowed values are: 0 to 7 number of possible retries
Pressing the [+] key or the {-} key increases or decreases this value.
Power Cycle Delay
Specifies the minimum time that must be expired before the system can
be switched on again after it has been switched off.
Allowed values are: 0 sec. to 15 sec.
Pressing the [+] key or the {-} key increases or decreases this value.
ASR&R Boot Delay
Specifies the system reboot delay after the system shuts down as a
result of an error (e.g. excessively high temperature). The system is
rebooted after the set wait time has expired.
Allowed values are: 1 min. to 30 min.