System expansio ns
Installing a nd rem oving 2½ inch drives in
a 3½ inch adapter
You c an install two non-accessible 2½ inch drives with a 3½ inch adapter in the lower and middle b ays.
Installing 2 ½ inch drives in a 3½ inch adapter
EasyChange rails for both drives are in the adapter.
a
► Fasten the E asyCh ange rails to the side of the first drive by inserting each pin of the
EasyChange rail in the correspo nding holes on the drive. In doing so, make sure that
the po rts on the drive are located at the rear as shown (a).
► Repeat the step for the s econd drive.
Fujitsu 45
To Next Page
Loading...
