Fujitsu ESPRIMO D75 Series - Installing and Removing a 2½ Inch Drive (Screw Fastened)

System expansio ns
It may be necessary t o modify the entry for the drive in the BIOS Setup.
Installing and removing a 2½ inch drive (screw fastened)
Installing a drive
► Remove the casing cover (see chapter "Removing the casing cove r ", Page 32).
► Fold ou t the drive cage (see chapter "
Opening the drive cage", Page 43).
2
1
► Slide the drive into the bay (1).
► Secure the d
rive with the screws (2).
► Connect the cables at the drive and at the mainboard. Make sure the polarity is correct.
► Fold the dr
ive cage into the closed position again (see chapter "
Closing the drive cage", Page 44).
► Fit the casing cover onto the casing again (see chapter "
Reattaching the casing cover.", Page 33).
If necessary, y ou must adjust the entry for the drive a ccord ingly in the BIOS Setup.
Fujitsu 51