|Document update record|
Table 12:
Feature release date Feature updates
August 2017
• Added bullet items in the “Controller-to-stack connection rules” section
under “Port pair connection rules”:
• You must include all SAS ports in your HA pair or single-controller
configuration when defining port pairs.
• When you should use (cable) port pairs in the order in which you
identified (listed) them and when you should skip port pairs.
• Updated the “Controller-to-stack cabling worksheets and cabling
examples for common multipath HA configurations” section to include
examples for skipping port pairs.
• Updated the “Controller-to-stack cabling worksheet template for
multipathed connectivity” section to include an example for skipping
port pairs.
• Updated the “How to read a worksheet to cable controller-to-stack
connections for multipathed connectivity” section to include an
example for skipping port pairs.
• Added a bullet item in the “Considerations for hot-adding disk shelves
with IOM12 modules” stating that nondisruptive stack consolidation is
not supported.
• Updated the “Controller-to-stack connection rules” section to more
concisely group port connection rules.
• Removed the “SAS disk shelf safety information” section.
All safety information can be found in the “Safety Information and
Regulatory Notices” document on the Fujitsu Support Site.
Fujitsu Support
• Updated headings for multipathed connectivity worksheets to specify
“multipathed connectivity”. (Headings previously stated “using IOM
ports 1 and 3”.)
50
To Next Page
Loading...
Need help?
General