Chapter 4 Setting the Backup Software
4.5 NetVault
FUJITSU Storage ETERNUS LT20 S2/LT40 S2/LT60 S2 Tape Library User’s Guide -Server Connection-
Copyright 2021 FUJITSU LIMITED P3AM-5322-12ENZ0
62
3 In the [Edit Drive] page that appears, click the [Configuration] tab and check that the [Cleaning
Tapes Supported] checkbox is selected. If cleared, select it.
4 Click the [OK] button to go back to the [Manage Devices] page in the tree view mode.
When the drive becomes idle, click the name of the same drive again and select [Configure].
5 In the [Edit Drive] page that appears, click the [Generic Cleaning] tab and set the following
Generic Cleaning items.
• When an LTO5 drive is used (model name: LT20SSH1, LT40SSH1, LT20SFH1, LT40SFH1,
LT60SSG1, LT60SFG1)
- Issue a load command to start cleaning cycle: on (the default setting is "on")
- Use Generic Cleaning: on (the default setting is "off")
• When an LTO6, LTO7, or LTO8 drive is used (model name: LT20SSK1, LT40SSK1, LT60SSK1,
LT20SFK1, LT40SFK1, LT60SFK1, LT20SSM1, LT40SSM1, LT60SSM1, LT20SFM1, LT40SFM1,
LT60SFM1, LT20SSN1, LT40SSN1, LT60SSN1, LT20SFN1, LT40SFN1, LT60SFN1)
- Issue a load command to start cleaning cycle: off (the default setting is "on")
- Use Generic Cleaning: on (the default setting is "off")
The following is an example setting for an LTO6, LTO7, or LTO8 drive.
To Next Page
Loading...
