Fujitsu ETERNUS - Page 43

Chapter 3 Startup and Shutdown
> 3.2 ETERNUSmgr for Windows®
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
43
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
• Checking any E-mails, and making sure that communication with the target device is normal
(if the E-mail notification function is used).
When monitoring multiple target devices, you must check each target separately. For example, if
monitoring three devices, browse each of the three logs to make sure that communications with
all are normal.
ETERNUSmgr treats any file that conforms to the "STX~.INI" format as a setup file, and loads it
accordingly. If ETERNUSmgr detects multiple setup files (for multiple devices), it will load all of
them. See
"2.1 Setup files" (page 15) for information about setup files.
The setup files are read automatically when ETERNUSmgr is started, but processing stops when
the following messages appear.
• When no setup files exist, or none can be read:
• When a "TARGET_ADDR" is not specified in a setup file, or is incorrect:
• When a "TARGET_ADDR" is missing, incorrect, or duplicated in multiple setup files:
• "TARGET_ADDR" is the parameter that specifies the address of the
target device.
• "STXPOLL_1.INI" indicates the name of the setup file in which the
error was actually detected.
"STXPOLL_1.INI" and "STXPOLL_2.INI" indicate the name of the setup
files in which the error was actually detected.