● 9 - 7
10. Select Back Density (when “Duplex” was Selected) by pressing or . As the cursor moves to the
right, / may appear. Then press . The scanner displays Screen 8.
Screen 8
11. Select Front Halftone by pressing or .
*) This parameter appears only when the IPC-4D(IMAGE PROCESSING CIRCUIT BOARD) is
installed.
Press to confirm. The scanner displays Screen 9.
Screen 9
12. Select Back Halftone (when “Duplex” was specified) by pressing or . The parameters are the
same as in step 11. Press to confirm. The scanner displays Screen 10.
Screen 10
Parameter
Description
No Halftone is Off. Therefore binary reading is specified.
H1 Halftone with dither is specified.
H2 Halftone with error diffusion is specified.
L1 (*) Automatic separation with dither is specified.
L2 (*) Automatic separation with error diffusion is specified.
=
No/ H1
/
H
2/ L1/ L2
0 8F.
H
a
l f tone.
=
No/ H1
/
H
2/ L1/ L2
09 B.
H
a
lftone.
=
Li ne/
P
h
ot o
1 0Fo
n
t
D oc.
To Next Page
Loading...
Need help?
General
