1. When the TWAIN driver is used; select [Use Memory on Scanner] or [Use both Memory] as [Cache
Mode] on the [Job/Cache] tab of the [Option] dialog box.
Without this step, you cannot continue scanning after a multifeed error.
2. When the ISIS or the TWAIN driver is used; if you want to start scanning by using the [Scan]
button after a multifeed error, configure the driver settings as described below.
[TWAIN driver]
Mark the [Enable Scanner Panel] and [Enable [Scan] Button] checkboxes on the [Startup] tab of the [Option] dialog
box.
[ISIS driver]
Mark the [On] checkbox under [Multifeed Recovery] and set [Auto-cancel Timer] to 0 or any value (minutes) on the
[Paper Handling] tab of the [Properties for Fujitsu fi-6130...] dialog box.
file:////10.232.227.50/Manual/fi-6130_6230_Lynx3L/OG/R02/02_081030/contents/EN/03/c03_18_01.htm (4/6) [2008/10/30 15:14:44]
To Next Page
Loading...
