Settings
Using the Software Operation Panel, you can configure the following settings for the scanner connected to the PC.
[Device Setting]
Item Explanation Selectable parameter Default
Page counter
(Consumables counter)
For evaluating the
consumable replacement
cycle.
Use this function to reset the
counters after replacing
consumables.
Pick roller/Brake roller/
remaining ink level
(only for the imprinter
option)
−
Power saving Select the waiting time before
entering the Power saving
mode.
Setting range 15 to 55
minutes (set in steps
of 5 min.)
15 min.
Offset Setting
Adjust the start position for
the document scanning.
Up down/Left right:
setting range -2 to 2
mm (set in 0.5 mm
steps)
Up down/left
right : 0 mm
Vertical magnification
Adjustment
Adjust the magnification in
the feeding direction.
Setting range -3.1% to
3.1% (set in 0.1%
steps)
0%
Device settings 2
file:////10.232.227.50/Manual/fi-6130_6230_Lynx3L/OG/R02/02_081030/contents/EN/08/c08_01_01.htm (2/5) [2008/10/30 15:15:00]
To Next Page
Loading...
