fi-6130 / fi-6230 Image Scanner Operator's Guide
TROUBLESHOOTING
CONTENTS MAP
TOP
8.7 Pre-Pick
To scan documents consecutively, you can previously pick the document to be scanned next. This operation is called Pre-Pick.
By enabling Pre-Pick, the time interval between the scanning of two separate documents can be shortened.
Configure the settings for the Pre-Pick as follows:
1. Start up the Software Operation Panel.
See Section "8.1 Scanner Settings."
2. Select [Device Setting 2] from left side list in the window, and select [Pre-Pick] from its lower
level.
3. Select [Yes] or [No] for Pre-Pick.
Select [Yes] to make Pre-pick valid, and select [No] to make it invalid.
To Next Page
Loading...
