Fujitsu fi-6670 Getting Started Guide

14
3) Gently close the Document Cover.
4) Change the position of the ADF.
The ADF can be set to any of the following three positions:
After repositioning the ADF, be sure that the ADF is firmly locked to the new position.
■
Traditional (Factory default)
■ Standard (Space-saving type and for right-handed
operators)
Slide the ADF toward the center of the scanner.
Note the following explanation in this manual is based upon
this standard type of the scanner.
■
Reversed (Space-saving type and for left-handed
operators)
Slide the ADF toward the center of the scanner, and then
rotate it counterclockwise by 180 degree.
4 Attach the Stacker and the ADF Paper Chute to the scanner.
1)
Insert the hooks of the ADF Paper Chute into their corresponding holes on the scanner.
2) Fit the protruding sections of the Stacker into their corresponding slots on the scanner.
CAUTION
• Be careful not to pinch your fingers when moving the ADF.
• Never rotate the ADF by more than 180 degree. Doing so may damage the ADF.
Protruding section
Hook

Fujitsu fi-6670 Specifications

General

Film scanning	No
Color scanning	Yes
Grayscale levels	256
Input color depth	24 bit
Maximum scan size	279.4 x 431.8 mm
Scanner type	Sheet-fed scanner
Sensor type	CCD
Maximum duty cycle	450000 pages per month
Auto document feeder (ADF) input capacity	200 sheets
Bundled software	Adobe Acrobat Standard, Kofax VRS Professional + Bar Code, ScandAll PRO, QuickScan Pro
Power requirements	AC 100 - 240V, 50 / 60 Hz
Maximum scan area (ADF) (imperial)	11 x 17 \
Minimum scan area (Auto Document Feeder)	2 x 3 \
Power consumption (standby)	6 W
Power consumption (typical)	216 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	299.72 mm
Width	431.8 mm
Weight	17009.7 g