Fujitsu fi-6670 Getting Started Guide

5
Warning Label
HOT warning label:
The glass surface inside the ADF becomes hot
during the operation. Be careful not to touch glass
surfaces inside the ADF.
To avoid burns, never touch around the area
indicated by this label.
Take care not to pinch your fingers while turning the ADF.
Safety Information
Warning Indications Used In This
Manual
The following indications are used in this manual to obviate
any change of accident or damage to you and/or the equip-
ment.
WARNING
The following are important warnings described in this manual.
You must NOT remove this warning label from your
scanner. When it gets old or unreadable by stain-
ing or scratches, contact the store where you
purchased the scanner or an authorized FUJITSU
scanner service provider.
WARNING
This indication alerts operators to an
operation that, if not strictly observed,
may result in severe injury or death.
CAUTION
This indication alerts operators to an
operation that, if not strictly observed,
may result in safety hazards to personnel
or damage to equipment.
A TRIANGLE symbol indicates that
special care and attention is required.
The drawing inside the triangle shows
the specific caution.
A CIRCLE with a diagonal line inside
shows action which users may not
perform.
The drawing inside or under the circle
shows the specific action that is not
allowed.
Outline characters on a colored
background show instructions users
should follow.
It may also include the drawing that
shows the specific instruction.
Do not damage the Power cable.
A damaged Power cable may cause fire or
electric shock. Do not place heavy objects on
Power cables, or pull, bend, twist, heat,
damage or modify Power cables.
Do not use damaged Power cables or power
plugs, or install any cables or power plugs to
loose wall sockets.
Use only specified Power cables and
interface cables.
Use only specified Power cables and interface
cables. Failure to use the correct cables might
cause electric shock and/or equipment failure.
Do not use the Power cable provided with the
scanner for other devices, since this might
cause equipment failure and other troubles or
an electric shock.

Fujitsu fi-6670 Specifications

General

Film scanning	No
Color scanning	Yes
Grayscale levels	256
Input color depth	24 bit
Maximum scan size	279.4 x 431.8 mm
Scanner type	Sheet-fed scanner
Sensor type	CCD
Maximum duty cycle	450000 pages per month
Auto document feeder (ADF) input capacity	200 sheets
Bundled software	Adobe Acrobat Standard, Kofax VRS Professional + Bar Code, ScandAll PRO, QuickScan Pro
Power requirements	AC 100 - 240V, 50 / 60 Hz
Maximum scan area (ADF) (imperial)	11 x 17 \
Minimum scan area (Auto Document Feeder)	2 x 3 \
Power consumption (standby)	6 W
Power consumption (typical)	216 W
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	299.72 mm
Width	431.8 mm
Weight	17009.7 g