Security functions
Access rights of SmartCards
SmartCardSmartCardSmartCard
A new SmartCard initially only has a preset PIN and PUK. Access rights and the customised
PIN and PUK are not assigned until the SmartCard is initialised. The SmartCard type
depends on the access rights assigned to the card, as described below:
• User SmartC ard: starting the system, changing the PIN
• SuperUser SmartCard: starting the system, changes in BIOS Setup, changing the PIN
• Service SmartCard: changes in BIOS-Setup,, cannot start the operating syst e m
• Admin SmartCard: starting the system, changes in BIOS Setup , c hanging the PIN,
uninstalling SystemLock, initialising SmartCards, blocking SmartCards
The following table shows an overview of the rights granted with each type of
SmartCard whe n a PIN or PUK is entered:
User
SmartCard
SuperUser
SmartCard
Service
SmartCard
Admin
SmartCard
PIN PUK PIN PUK PIN PUK PIN PUK
Start-up system
xx x
Run BIOS Setup
xxx
Change own PIN
xx xxx
Unblocking own
blocked SmartCard
x* x* x*
x
Unblock all blocked
SmartCards
x
Generating u ser cards
x
Uninstall SystemLock
x
* BIOS Setup setting (Unblock own SmartCard)
Usually there is always one Admin Sma rtCard and at least one User or SuperUser
SmartCard that will allow a system to be operated.
84 Fujitsu Technology Solutions
To Next Page
Loading...
