Fujitsu LIFEBOOK U9311 - Error Messages on the Screen

Tro ubleshooting and tips
Error messages on the screen
Errormessages onthescr eenErrormessage:
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact the place of purchase or our customer service centre.
Error message/c ause Resolution
CMOS battery bad
If the error message occurs repeate dly, the
buffer battery in the notebook is flat.
► C ontact your sales outlet
or our customer
service centre.
System CMOS check sum bad - default config uratio n
used
The system configuration information is
incorrect.
► Sw itch the notebook of
f.
► Sw itch the notebook on.
► Press the function k
ey
F2
to access the
BIOS Setup.
► In the BI OS Setup, select the Exit menu.
► Se lect the entry Lo
ad Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory an error has
resulted at the address xxxx.
► C heck whether the additional memory
module has been inserted correctly.
Failure Fixed D isk n
The settings of the hard disk drive are incorrect.
► Start the BIO S Setup (Primary Master
submenu) and select the correct settings.
Keyboard controller error
► Sw itch the notebo ok off using with the
ON/OFF button.
► Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you are using an external keyboard:
► C heck the connection and reboot the
notebook.
nn Stuck key
► M ake sure that no key is pressed.
Operating system not found
► C heck
in the BIOS Setup whether your hard
disk h
as been set correctly.
► Make sure that the operating system is
installed on the corresponding drive.
Press <F1> to resume, <F2> to SETUP
This error message appears if an error occurs
during the self-test before starting the operating
system.
► Press the
F1
function key to s tar t the
operating syste m.
► Press the function key
F2
to access the
BIOS Setup.
Fujitsu 71