5.3 Host Commands
(10) STANDBY IMMEDIATE (X’94’ or X’E0’)
Upon receipt of this command, the device enters the standby mode. The device
then reports the status to the host system. This command does not support the
APS timer function.
• Error reporting conditions
(1) A SATA communication error occurred (ST = 51h, ER = 14h).
At command issuance (Shadow Block Registers setting contents)
CM X’94’ or X’E0’
DH x x x x Xx
CH
CL
SN
SC
FR
xx
xx
xx
xx
Xx
At command completion (Shadow Block Registers contents to be read)
ST Status information
DH x x x x Xx
CH
CL
SN
SC
ER
xx
xx
xx
xx
Error information
C141-E254 5-47
To Next Page
Loading...
