Fujitsu MHX2300BT - IDLE IMMEDIATE (X95 or XE1);UNLOAD IMMEDIATE (X95 or XE1)

Interface
(11) IDLE IMMEDIATE (X’95’ or X’E1’) /UNLOAD IMMEDIATE (X’95’ or X’E1’)
• Default Function
Upon receipt of this command, the device enters the idle mode. Then, the device
reports the status to the host system. This command does not support the APS
timer function.
Error reporting conditions
(1) A SATA communication error occurred (ST = 51h, ER = 14h).
At command issuance (Shadow Block Registers setting contents)
CM X’95’ or X’E1’
DH x x x x xx
CH
CL
SN
SC
FR
xx
xx
xx
xx
xx
At command completion (Shadow Block Registers contents to be read)
ST Status information
DH x x x x xx
CH
CL
SN
SC
ER
xx
xx
xx
xx
Error information
5-48 C141-E254