PR-LN4 Software Guide
CHAPTER 1 INTRODUCTION
1.1 OVERVIEW
This manual describes how to configure and how to use the PR-LN4 used by the printer.
Read this manual thoroughly to ensure you use the product correctly and safely.
When using a Windows printer driver via the LAN, you need to configure the LAN information and create an original
TCP/IP ports for this printer. You can configure these settings easily by using the "LAN Settings Tool".
1.2 RELATED DOCUMENTS
Related documents are shown in the following table. Refer to them as necessary.
Reference Folder / File Name
\Documents\User's Manual\(Printer Name)\(Language)\Cxxx-Exxx-01xx.PDF
Printer Driver Installation Guide
\Documents\Install Guides\Installguide_xx.PDF
Status Monitor User's Manual
\Documents\Status Monitor User's Manual\StatusMonitorUser'sManual_xx.PDF
1.3 SYSTEM REQUIREMENTS
(1) Personal computers equipped with the following interfaces and running a supported operating systems.
(2) The ".NET Framework 3.5 SP1" or higher is required in order to use this tool.
If it is not installed, obtain and install the ".NET Framework 3.5 SP1" from the Microsoft website.
(3) Administrator privileges are required in order to run this tool.
Log into the Administrators account to run.
To Next Page
Loading...
