RX100 S4 Service Supplement 31
Replacement routines Replacing the system board
Ê Lower the system board carefully into the chassis.
Ê Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion.
Ê Fasten the system board with the nine screws.
Ê Reconnect the cables to their original connectors (see the cabling plans in
the Options Guide).
Ê Install the memory modules (for a description see the Options Guide).
Ê Install the processor (for a description see section “Replacing the processor”
on page 25).
Ê Install the riser card holder in its former slot (for a description see the Options
Guide). If controllers have been installed, connect their cables.
Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
Ê Connect all external cables.
V CAUTION!
After installing the new system board, it is necessary to update the BIOS
to ensure proper operation (for a description see the BIOS Manual).
After installing the new LED board, it is necessary to program the
ChassisID prom with the help of the "ChassisIDProm Tool" to enable
ServerView and ServerStart to identify the system.
You will find the tool on the ServerSupport CD and/or it can be
downloaded from the Fujitsu Siemens Computers Service and
Support page (URL:
http://extranet.fujitsu-siemens.com/service/information/intelservers/tools).
To Next Page
Loading...
