16 Operating Manual RX2510 M2
Power supply
In its basic configuration the server uses a hot-plug power supply unit that
adjusts automatically to any mains voltage in the range of 100 - 240 V (PSU
Platinum, 450 W).
As an option, the power supply can be expanded with an extra power supply unit
to create a redundant power supply. If a power supply unit fails, the redundant
configuration assures continued operation. The defective power supply unit can
be replaced during operation.
Fujitsu Advanced Thermal Design
The Fujitsu Advanced Thermal Design option allows you to operate the system
with a wider temperature range either of 5 °C to 40 °C or 5 °C to 45 °C,
depending on your system and configuration.
V CAUTION
In a system that is configured with Fujitsu Advanced Thermal Design,
only certain components which support the respectively increased higher
operating temperature range may be installed and used. For applicable
restrictions, please refer to the official configurator tool.
High level of availability and data security
When memory data is accessed, 1-bit errors are identified in the main memory
and automatically corrected with the error correcting code (ECC) method.
ASR&R (Automatic Server Reconfiguration and Restart) restarts the system in
the event of an error and automatically "hides" the defective system
components.
The PDA (Prefailure Detection and Analysis) technology from Fujitsu analyzes
and monitors all components that are critical for system reliability.
A RAID controller supports different RAID levels and increase the availability
and data security of the system.
The hot-plug HDD modules provide additional availability.
This option can only be ordered from the
manufacturer and is indicated by the respective
logo on the identification rating plate.
To Next Page
Loading...
Need help?
General