38 Operating Manual RX2510 M2
The use of shielded I/O cables is required when connecting this equipment to
any and all optional peripheral or host devices. Failure to do so may violate FCC
and ICES rules.
WARNING:
This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
4.3 Transporting the server
V CAUTION!
Only transport the server in its original packaging or in packaging that
protects it from impacts and jolts. Do not unpack the server until it is at its
installation location.
If you need to lift or transport the server, ask other people to help you.
Never lift or carry the device by the Quick Release Levers (QRLs) on the
front panel.
4.4 Notes on installing the server in the rack
V CAUTION!
● For safety reasons, at least two people are required to install the
server in the rack because of its weight and size.
(For the Japanese market, please refer to " 安全上のご注意 ".)
● Never lift the server into the rack using the QRLs (Quick Release
Levers) on the front panel.
● When connecting and disconnecting cables, observe the relevant
instructions in the "Important Information" chapter of the technical
manual for the corresponding rack. The technical manual is supplied
with the corresponding rack.
● When installing the rack, make sure that the anti-tilt mechanism is
correctly fitted.
To Next Page
Loading...
