Fujitsu PRIMERGY TX150 S8 System Configurator And Order-Information Guide

System configurator and order-information guide
M
PRIMERGY TX150 S8 Status 2016-02-29
Section
VIII
internal Disk Array
All Base Units contain a 6-port on-board SATA controller supporting RAID Levels 0, 1, 10
If a SAS Backup drive is configured, then the 4 SATA HDD boards are not available any more
If no SAS Backup drive is configured, then there is an optional SAS onboard controller available for up to 4 SAS HDDs
For more than 4 HDDs or for any HDD in combination with a SAS tape
it is necessary to select an 8 port PCI based RAID0/1 or RAID5 controller!
S26361-F3669-E1/E3 does not support
3.5" ECO SATA HDD (S26361-F3700-E250/E500)
SAS RAID Controller for up to 4 SAS HDDs
S26361-F3674-E1
Onboard 4 port SAS Controller
LSI
Patsburg B replaces 4 onb. SATA ports
RAID 0, 1 & 10
no controller cache
SAS 6Gb/sec
4 internal ports
PCIe x4
no PCI slot required
max. 1x per system
A mix of onboard RAID and HW RAID
is not allowed!
Controller for 1 to 8 LFF (3.5") or SFF (2.5") HDD
S26361-F3554-E8 S26361-F3554-E512 S26361-F3669-E1 S26361-F3669-E3
RAID Ctrl SAS 6G 8port int. RAID Ctrl SAS 6G 8port internal
RAID Ctrl SAS 6G 8port internal
RAID Ctrl SAS 6G 8port internal
Based on chip LSISAS2008 Based on chip LSISAS2108 Based on chip LSISAS2208 Based on chip LSISAS2208
1x for LFF base
LSI MegaRAID
LSI MegaRAID
LSI MegaRAID
LSI MegaRAID
2x for SFF, but
no Cache, no BBU 512MB Cache with ECC 1GB Cache with ECC 1GB Cache with ECC
max. 3x
RAID 0, 1 & 1E RAID 0, 1, 10, 5, 50, 6, 60 RAID 0, 1, 10, 5, 50, 6, 60 RAID 0, 1, 10, 5, 50, 6, 60
RAID ctrl Sup. for 3Gb/s and 6Gb/s
optional BBU
optional FBU
optional FBU
int. and ext. SATA and SAS HDs Support for 3Gb/s and 6Gb/s
Support for 3Gb/s and 6Gb/s
Support for 3Gb/s and 6Gb/s
in total PCIe x8 SATA and SAS hard drives
SATA and SAS hard drives
SATA and SAS hard drives
Low-prof. MD2 form factor
PCIe x8 PCIe x8 PCIe 3.0 x8
max. 1x / 2x per system
Low-profile MD2 form factor Low-profile MD2 form factor Low-profile MD2 form factor
max. 1x / 2x per system max. 1x / 2x per system
max. 1x per system
S26361-F3257-E216 S26361-F3669-E100
Cache Battery Backup Unit TFM Module for FBU option
max. 1x per Controller max. 1x per Controller
S26361-F3669-E125
L-Order-Number is:
Flash Backup Unit
S26361-F3257-L210
with 25cm cable set
max. 1x per Controller
Advanced Software Option
RAID Advanced Software
S26361-F3669-L660 S26361-F3669-E660
free of charge test licence
RAID Advanced Software Options RAID Advanced Software Options
avaliable: PRIMERGY-PM
License Activation Key License Activation Key
for CacheCade Pro 2.0 & FastPath for CacheCade Pro 2.0 & FastPath
for 1 Controller for 1 Controller
N
for loose delivery
S26361-F3669-L100
of TFM & FBU please
TFM Module for FBU option
The FBU is an option for the controller order:
which can be used once per controller.
max. 1x per Controller
If the FBU option has been choosen, the
TFM Module is needed once per FBU.
S26361-F3669-L110
Flash Backup Unit
with 25cm, 55cm, 70cm cable set
max. 1x per Controller
Fujitsu PRIMERGY Server 19 of 24

Fujitsu PRIMERGY TX150 S8 Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX150 S8
Category	Server
Language	English