Need help?Do you have a question about the Fujitsu PRIMERGY TX150 S6 and is the answer not in the manual?
General| Form Factor | Tower |
|---|---|
| Processor Sockets | 1 |
| Memory Slots | 4 |
| Network | 2 x Gigabit Ethernet |
| Memory | Up to 32 GB |
| Storage | 4 x 3.5-inch |
| RAID Support | RAID 0, 1 |
| Operating System | Windows Server, Linux |
Critical safety guidelines and warnings for handling and operating the server.
Procedures for installing the server into various types of racks.
Instructions for connecting the server's power supply to electrical outlets.
Explains the function of buttons, LEDs, and indicators on the server.
Identifies and describes controls and indicators on the server's front panel.
Procedures for powering the server on, off, and standby modes.
Guides on configuring onboard controllers and installing the OS.
Steps for configuring the integrated SATA controller.
Configuration steps for the PCI SAS controller with IME.
Configuration steps for the PCI SAS controller with RAID.
Instructions on using ServerStart for configuration and OS installation.
Steps for configuring the server and installing the OS without ServerStart.
Diagnoses and resolves issues with the power-on indicator.
Addresses problems where the server unexpectedly shuts down.
Troubleshooting steps for when the monitor displays nothing.
Step-by-step guide for replacing a hot-plug power supply unit.
Information on hot-plug HDD modules and their handling.
Steps to install a new HDD module into the server.
Procedures for safely removing a hot-plug HDD module.
Step-by-step guide for replacing memory modules.
To Next Page
