56 Operating Manual TX150 S6
Mounting the rack model Hardware installation
4.3.3 Installation in 3rd party racks
For installation in a 3rd-Party rack, the following parts are required:
– two Vario support systems including telescopic rail and system support
– possibly protective hose for fiber channel fiber optic cable
Ê Refer to the original manual from the rack manufacturer for details of the
mechanical installation and the climatic conditions.
V CAUTION!
When installing in 3rd party racks, it must be ensured that an air flow
from the front to the back of the rack is guaranteed.
I Under certain circumstances, you will not be able to use some of the
parts from the rack installation kit supplied - you will need to use
original 3rd party rack parts instead.
Ê Fit the prepared rails in the 3rd party rack, as described in section “Instal-
lation in PRIMECENTER/DataCenter Rack” on page 45.
Ê Insert the server (see section “Inserting the server” on page 57).
Ê Route the cables as described in the original rack manual.
To Next Page
Loading...
