EasyManua.ls Logo

Fujitsu PRIMERGY TX2550 M5 - Setting up the floorstand model

Fujitsu PRIMERGY TX2550 M5
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX2550 M5 Operating Manual 61
Starting up
5.3 Setting up the floorstand model
I If you are not installing a PRIMERGY TX2550 M5 floorstand model, skip
this section and continue reading at section "Installing the server in the
rack" on page 62.
V CAUTION!
Note the safety instructions in chapter "Important information" on
page 43.
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see section "Unpacking the server" on page 60).
Ê Set up the server.
V CAUTION!
The device must be protected from direct sunlight.
The required minimum distances for operation and maintenance
areas must be adhered to.
The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
The mains plug must be accessible easily and safely.
There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the
subsystem.
Ê Connect the devices to the server, see section "Connecting devices to the
server" on page 68 and section "Notes on connecting/disconnecting cables"
on page 67.
Ê Connect the server to the mains, see section"Connecting the power cord" on
page 69.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX2550 M5

Related product manuals