Fujitsu PRIMERGY TX300 - Setting up the Floorstand Model

A26361-K881-Z102-4-7619 27
Hardware Installation Setting Up the Floorstand Model
4.3 Setting Up the Floorstand Model
I If no floorstand model is to be installed continue with section
“Installing/Removing the Rack Model into the Rack” on page 29:
V CAUTION!
Please note the safety instructions in chapter “Important Notes” on page 13.
Ê Transport the server to the place where you want to set it up.
Ê Unpack the server (see section “Unpacking the Server” on page 26).
Figure 2: Mounting HDD cover
2
1
4
3
3