A26361-K881-Z102-4-7619 63
Preparation for Use and Operation Switching the Server ON and OFF
5.3 Switching the Server ON and OFF
V CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see chapter “Trouble-
shooting and Tips” on page 71).
The ON/OFF button does not disconnect the server from the mains. To
disconnect from the mains completely, remove the power plug.
Switching the server ON
– First system installation:
Ê Press the ON/OFF button (position 1in figure 24 on page 55).
Ê Insert the ServerStart-CD and/or an installation disk in the corresponding
drive.
Ê Follow the instructions on the monitor (see also section “Configuration
with ServerStart” on page 66 and/or section “Configuration without
ServerStart” on page 67).
– System already installed:
The power-on indicator (position 2in figure 24 on page 55) lights orange
(standby mode).
Ê Press the ON/OFF button (position 1in figure 24 on page 55).
The server is switched ON, performs a system test and boots the
operating system.
Pos. Power
indicator
(green)
Error
indicator
(orange)
Status description
1 does not
light
does not
light
Device switched OFF.
2 lights does not
light
Device operating.
PCI slot powered up.
Table 4: Operating system without hot-plug functionality: hot-plug PCI indicator modes
To Next Page
Loading...
