30 A26361-K881-Z102-4-7619
Installing/Removing the Rack Model into the Rack Hardware Installation
DataCenter Rack
– Frontally or laterally bolted telescopic rails or sliding rails (except within the
rear left area where a support bracket is used).
– Extended cable management within the lateral rack area.
19-Inch (Classic) Rack
– Directly laterally bolted telescopic rails or sliding rails.
– Cable management by using an articulated cable carrier.
The mounting of the rails in the different racks is described in the next sections.
The mounting of the cable management is described in detail in the Technical
Manual to the respective rack.
To rack systems of different foreign manufacturers the following applies:
3rd-Party Rack
Certain boundary conditions are to be fulfilled:
– Installation dimensions (see the dimensions shown in figure 3 on page 31).
1 rack front side
2 rack rear side
A rack depth (comparison PRIMECENTER Rack 940/1000 mm)
B rack width (comparison PRIMECENTER Rack 700 mm)
C clearance of the 19-inch installation level
C1 front 19-inch installation level
C2 rear 19-inch installation level
D area for cable routing (cable area depth) and ventilation
E area for front panel and ventilation
F right and left area for support systems
P PRIMERGY installation depth
a1 front left support upright
a2 front right support upright
b1 rear left support upright
b2 rear right support upright
To Next Page
Loading...
