A26361-K881-Z102-4-7619 57
Preparation for Use and Operation Operating and Indicator Elements
Indicators on the control panel
Power-on indicator (bicolor)
Lights orange when the server is switched OFF, but mains voltage is
present (standby mode).
Lights green when the server is switched ON.
Flashes red/orange when the server is connected to the line voltage
for first time or it is again in standby mode after a power failure.
Drive active indicator
An internal SCSI drive (HDD or backup drive) is being accessed.
Global Error indicator
Does not light when the system is ok. The power is ON, no service
incident or event has occurred.
Flashes orange when a critical event has occurred. Users can
check BIOS Setup, system- and eventlog or via ServerView for
event details. The indicator also flashes in standby mode.
Lights orange when a prefailure event has been recognized.
Users can check system- and eventlog or via ServerView for event
details. The indicator also lights in standby mode.
If the event is still acute after a power failure, the indicator is
activated after the restart.
ID ID indicator (blue)
Lights blue when the system has been selected by pressing the
ID button. To deactivate, press the button again.
The ID indicator can also be activated via ServerView and its status
reported to ServerView.
?
To Next Page
Loading...
