Fujitsu ScanSnap S1300i - Page 44

Turning the ScanSnap ON/OFF
44
2. Open the ADF paper chute (cover) of the ScanSnap to turn the power
on.
 The [Scan] button flashes in blue. The button returns to being lit normally when
document scanning is enabled.
The ScanSnap Manager icon changes as shown below.
From to (
for USB bus power cable connection).
From to (
for USB bus power cable connection).
ATTENTION
With some computers, the initialization of the ScanSnap may be performed several times when the
computer is started up.
HINT
There may be a slight delay before the ScanSnap Manager icon changes to or , depending
on your computer's performance, operating environment, and load such as when multiple programs
are running at the same time.