ServerView Event Manager 111
Trap overview
5.3.10 MultiPath traps (mp.mib)
MIB-OID: 1.3.6.1.4.1.231.2.10.2
This section lists MultiPath traps in alphabetical order.
Trap name ID Meaning Error class
sieMP
ActivePortChanged
1202 The user has enabled or
disabled a path of a
MultiPath group.
informational
sieMPAutoRecovered 1205 A path of a MultiPath group,
which was in error status, is
accessible again due to
automatic recovery.
informational
sieMPError 1200 A MultiPath group now
consists of only one path,
and an error has been
detected for this path. The
MultiPath group is not
operational anymore.
critical
sieMPErrorCleared 1206 A user has cleared the error
status for a path of a
MultiPath group.
informational
sieMPReconfigured 1203 A path has been removed
from or added to a
MultiPath group.
informational
sieMPRetry 1201 An error has been detected
on a path of a MultiPath
group. An attempt is being
made to execute the
command on another path
of the MultiPath group.
critical
sieMPStatusChanged 1204 A user has made a change
to a MultiPath group
(autorecovery was turned
on or off, loadbalancing was
turned on or off, or one path
was enabled or disabled.
informational
Table 27: MultiPath traps
To Next Page
Loading...