● Load plastic cards one at a time in the ADF paper chute (feeder).
● It is recommended to place the card face-down in the ADF paper chute (feeder).
● Rigid cards may not be fed properly.
● If there is dirt on the surface of the card, such as grease marks (fingerprints), perform scanning after wiping
the dirt off.
● Scanning a thick document such as a plastic card will always be falsely detected as overlapped documents.
In such a case, disable the setting in the image scanning application or scanner driver so that overlapped
documents (multifeeds) are not detected, and then try scanning again.
How to Load Documents
55
To Next Page
Loading...
