*1:Long page scanning supports documents with a length up to 3,048 mm (120 in.).
To scan documents that are longer than 355.6 mm (14 in.) but are within 863 mm (34 in.), set the
resolution to 300 dpi or lower.
To scan documents longer than 863 mm (34 in.), set the resolution to 200 dpi or lower.
*2:Note that this is the hardware limitation, and the software's processing time such as data transfer time is
added to the actual time of scanning.
The scanning speed is the same when the scanner is connected via a USB or via a wired LAN.
*3:The capacity varies depending on the paper weight.
For details, refer to Documents for Scanning (page 50).
*4:Use the USB cable that is supplied.
When connecting the USB cable to a USB hub, make sure you connect it to a USB hub that is connected to
the USB port of a computer.
Connection with USB 3.2 Gen 1x1 (USB 3.0)/USB 2.0 requires the USB port and the hub to support USB 3.2
Gen 1x1 (USB 3.0)/USB 2.0.
Also note that the scanning speed slows down when USB 1.1 is used.
If you connect the USB cable to the scanner, connect the USB cable with the USB logo on the head of the
cable facing upwards.
*5:IPv6 is not supported.
Appendix
139
To Next Page
Loading...
