Fujitsu SP-1130Ne - Connecting the Scanner Via a Wired LAN (When Assigning an IP Address Manually)

Connecting the Scanner via a Wired LAN (When Assigning an IP Address
Manually)
This section explains about the setup procedure for you to connect the scanner to a computer via a wired LAN and
manually assign an IP address to the scanner.
For the procedure to unpack the scanner, refer to Getting Started.
ATTENTION
If an old version of the software is installed, uninstall it first.
For the procedure to uninstall the software, refer to Uninstalling the Software (page 142).
1 Turn on the computer and log onto Windows as a user with administrator privileges.
2 Download the installer from the download site (http://sp-ne.com/d/).
3 Double-click the downloaded installer.
The [SP Series Setup] window appears.
4 Check the information and click the [Next] button.
5 Click the [Install] button.
6 Install the software by following the instructions displayed in the window.
The [How to Connect the Scanner] window appears when the installation of the software is complete.
Scanner Setup
23