Controller Clip limiter settings (if fitted)
Notes
These settings will limit the amplifier’s long-term output to 1dB below your F81’s power rating
Check that the main output limiter settings are preventing continuous clipping by testing the
controller/amplifier combination at high signal levels off-load (i.e. with the loudspeaker
unplugged)
If necessary, reduce the output limiter threshold level to eliminate any continuous clipping
Assuming that the amplifier has adequate continuous power, adjustments of more than 1 or 2dB
may indicate a problem with the mains voltage or the amplifier gain settings
11.3 Limiter settings vs amplifier sensitivity
If gain figures are not available, the table below will allow you to estimate long term controller limiters
for your F81s from your amplifier’s output and sensitivity figures.
Initial controller limiter settings vs amplifier output and sensitivity for F81 systems
Timing and clip limiter settings on next page...
www.funktion-one.com © Funktion One Research Limited 2011
To Next Page
Loading...