You may cancel each voice dialogue at almost any time with another prolonged pressing of the key. If the EGO FLASH is wai-
ting for a voice command, you may end the dialogue by saying “abort”.
If there is no Bluetooth
®
phone connected to the EGO FLASH, voice-activated dialing cannot be activated.
The following voice commands are possible:
→ “Call / dial <name>”
→ “Call / dial <name> at home …
at work / in the office / on business …
on the cell phone”
→ “Dial number”
→ “Help”
→ “Redial / call again”
→ “Abort / Cancel”
“Call / Dial <name>”
This command may be used to select a name from the contacts list. The name must be contained in the contacts list for this com-
mand to function. If the name is not recognized or found, the EGO FLASH responds with “Please repeat” and offers you the chance
to repeat the command. If the name is recognized, you will be asked if the name should really be dialed. The following commands
are available to you:
→ “Yes / Call / Dial” Dials the number stored under that name
→ “No / Back” The number for the recognized name is not dialed
→ “Abort / Cancel“ Ends the dialogue without carrying out a function
→ “Help” Calls up Help and an explanation of possible commands
“Call / Dial <name> at home … on the cell phone”
With this command, you may dial a specific type of number from a contacts list entry. If the name is recognized, you will be asked
if the name should really be dialed. The following commands are available to you:
→ “Yes / Call / Dial” Dials the number stored under that name
→ “No / Back” The number for the recognized name is not dialed
→ “Abort / Cancel“ Ends the dialogue without carrying out a function
→ “Help” Calls up Help and an explanation of possible commands
EGO FLASH
To Next Page
Loading...
Need help?
General
