1. MOUNTING
1-13
1.4 How to Install the FA-1703 Pilot Plug Unit (op-
tion)
The pilot plug unit is only available in the flushmount configuration and should be
mounted near where the pilot steers the ship. This plug is used to connect a PC to dis-
play AIS information for use by the pilot.
1. Cut a mounting hole in the mounting location, referring to the outline drawing at
the back of this manual for mounting dimensions.
2. Feed the necessary cables through the cutout, then referring to chapter 2, con-
nect the pilot plug unit.
3. Set the pilot plug unit to the cutout. Use caution to prevent damage to cables when
setting the pilot plug unit into the cutout.
4. Secure the pilot plug unit in place with the supplied screws, referring to the figures
above.
Console
Pilot plug unit
Mounting panel
AIS
PILOT PLUG
FA-170
Screw locations
To Next Page
Loading...
