3. SETTINGS AND ADJUSTMENTS
3-2
3.1 How to Set MMSI, IMO No., Name and Call Sign
This section covers the basic setup for CLASS A AIS systems. Inland AIS systems re-
quire several Inland AIS specific settings, outlined in section 3.2.
1. Access the [INITIAL SET] menu, following the procedure outlined in "How to ac-
cess the [INITIAL SET] menu" on page 3-1.
2. Select [SHIP’S INFORMATION], then press the ENT/ACK key.
3. Select [MMSI], then press the ENT/ACK key to display the [MMSI] pop up win-
dow.
Note: [ENI], [SPEED QUALITY], [COURSE QUALITY], [HEADING QUALITY]
and [BLUE SIGN SW] are Inland AIS settings. These items do not appear for other
AIS modes. For Inland AIS settings, see section 3.2.
4. Use the arrow keys to set the [MMSI], then press the ENT/ACK key. The charac-
ters are cycled in the following order when is pressed: 1, 2 ... 9, 0, 1, 2... press
to cycle through characters in the opposite direction. Press or to move the
selection cursor.
5. Input the IMO number in a similar manner to MMSI.
IMO: Ten digits. If the IMO number has 8 digits, enter “0” twice followed by IMO
number. If the ship has no IMO number, enter ten zeros. Inland AIS is fixed at "0".
6. For [NAME] and [CALL SIGN], the software keyboard is displayed when the item
is selected.
7. Select [TYPE OF SHIP] referring to section 1.5 of the operator’s manual, then
press the ENT/ACK key. This item is not available in Inland mode.
8. After entering data, press the DISP key to close the menu.
Note: If you enter incorrect data, do the procedure from step 1.
1) Referring to the figure above, press the arrow keys to select a character or key-
board operation.
2) Press the ENT/ACK key to confirm your selection.
3) Repeat steps 1 and 2 to complete the alphanumeric input.
4) Select [SET], then press the ENT/ACK key.
SHIP’S INFORMATION
MMSI 234556789
FURUNOMARU
1234567890
SPEED QUALITY HIGH
HIGH
HIGH
UNUSE
COURSE QUALITY
HEADING QUALITY
BLUE SIGN SW
(
WIG
)
24
@SEVEN@
00100000
NAME
IMO NO.
CALL SIGN
ENI
TYPE OF SHIP
0075
0076
[
LONG RANGE
]
CH A
CH B
: BACK
MENU
000000000
MMSI
Not shown where
[
REGULATION
]
is
set to
[
JAPAN
].
TEXT
Cursor position is shown as a blue bar.
Backspace - Erase the character
to the left of the cursor.
Delete - Erase the character to
the right of the cursor.
Cursor locators - Press ► to
move the cursor rightward, ◄ to
move the cursor leftward.
SET - Apply the changes.
Current selection is highlighted in blue.
Keyboard operation keys
To Next Page
Loading...
